22
Kalea Bay LED Outdoor Fireplace
REV. 4-17-19 Page 16
This fireplace is equipped with LED lighting.
Preparation for the LED lighting a must be planned before the fireplace
finish materials are installed
. After the fireplace is set in its final location the LED lighting will need to be installed and
tested before finishing materials are applied. You will need to provide the following:
(1) 120VAC GFCI outlet double gang junction box with a weatherproof cover. Provides power to LED lights and gas valve
system. Follow local electrical codes for installation.
A RGB control box with switches is provided with the fireplace. It must be installed within the framing parameters of the
fireplace.
Step 1:
Install the GFCI outlet
double gang junction box with a
weatherproof cover on the opposite
side of the inlet gas supply.
Note
: This is not a requirement;
however, with the gang box on the
opposite side of inlet will create
more room for LED installation.
Fig. 15 shows GFCI gang box
installed.
Step 2:
Find mounting location for the GFCI gang box. Fig. 14 shows flat area underneath burner pan. Mount box
underneath the burner pan, below the square (cutout) hole area. Fig. 15 shows the GFCI outlet double gang junction box
with a weatherproof cover mounted underneath the fireplace.
Burner Pan
Support leg under fireplace
Bo
tto
m
su
pp
or
t fi
n
GFCI Outlet installed in a double
outlet NEMA 3R enclosure
(Bring electrical up
from underneath
the fireplace)
Fig. 14
GFCI box location under fireplace
GFCI Outlet installed in a double
outlet NEMA 3R enclosure
Fig. 15
Show GFCI box mounted in fireplace
LED LIGHTING INSTALLATION
36” Model = 13”
48“ Model = 18”
60“ Model = 24”
72” Model = 30”
5”
11½”
TYP
Electrical Area (GFCI)
The electric junction box (GFCI) with a weatherproof cover must be installed in
the shaded area shown below. Ensure the j-box is close to the floor area where
the fireplace is sitting and not touching the burnerpan.
Fig. 13
Electrical placement.
KALEA BAY: E LED
