Firegear FPB-G34DBSMT-N, Инструкция по установке и эксплуатации

Страница: 16 / 26

I
NSTALLATION OF BATTERY PACK
1. During the installation the location of the battery pack should be installed in the location that is easy to service.
The best location is in the vertical enclosure of the fire pit. The plastic junction box is provided for the installation
of the battery pack.
Requires 4-AA 1.5V
alkaline batteries
Batt
ery c
over
slid
es o
n/off
La
tc
hin
g S
ole
no
id
D
C
M
oto
r D
riv
e
Slide Switch
to Latching
Solenoid
2. The wiring extending from the valve box is a 12-foot special 4-pin connector that connects to the battery pack and
(2) two additional wires with ¼” female connectors. A complete wiring diagram (Fig.26) is located on page 20.
3. Feed all wires into the plastic junction box and connect special 4-pin plug into back of the battery pack. Connect
¼” female spade connectors to solenoid wires matching color, red-to-red and black-to-black.
4. Install the (4) AA batteries in to the battery compartment shown in figure 19. Double check to ensure the slide
switch is in the latching solenoid position on the battery pack. Then snap cover plate in place as shown in fig.20.
Fig. 19
.
Slide switch on latching solenoid
5. Reinstall the battery pack into the plastic junction box, line up the two holes in the cover and install white screws
provided. Batteries can be changed or installed by removing the two screws that hold the cover plate battery pack
in place. Remove assembly, slide cover away from the cover plate and install the (4) four AA batteries.
6. Be sure the batteries are installed positive-to-positive and negative-to-negative. If one battery is installed wrong
the system will not operate.
7. Once the fire pit is installed into the enclosure, the burner and control system should be tested before the media
(lava rock) is installed.
INSTALLATION OF BATTERY INTO TRANSMITTER
You have one handheld transmitter and you will need to install the included (12-volt battery) into the transmitter. On the
backside of the transmitter, push the cover away from the case. Place the battery into the compartment matching positive-
to-positive and negative-to-negative. To ensure the battery is properly installed push any button on the transmitter and
you will see a red LED light at the top of the transmitter glow. The red LED light will only be lit when a button is pushed.
Fig. 20 Cover plate installation
IGNITOR ALIGNMENT
It is important check that the ignitor probes be properly
aligned overtop of the burner port holes and did not move
during shipping. Use the Fig. 21 as a guide. Before lighting
remove the screen cover of the ignition hood to burner and
ensure the spark probes are directly overtop of a burner port
hole. The sparking probes and the thermocouple must be in
the path of a flame to ignite the gas for proper ignition of the
flame. Replace the screen cover and follow the operating
instructions.
F
ig. 21 Proper alignment of probes and thermocouple
.
Thermocouple
Ignitor Probes
Igniton
Hood
SECTION C THERMOCOUPLE FLAME SENSE INST
ALLA
TION
REV. 5-7-14 Page 15 Flat Disc Burning Spur Fire Pits
Battery Pack
Cover Plate
(Rear View)