REV. 4-13-16 Page 4
Cradle
Burner Trim
Cradle Bracket
Cradle Bracket
Burner Tube
(Under Screen Gard)
Extension Bracket
Pilot Cover
Pilot Cover
Gas Inlet Centered
Underneath Cradle
When in stalling into an opening its important to note some installation dimensions.
1) Cradle - is the assembly (outer shell) that all other parts sit inside. It is also the box where all rough framing takes
place. See page 3 and 4 for details.
2) Cradle Bracket - These brackets are 23” long with 2” flanges. Each Linear model comes with two (2) cradle brackets
that mount on both sides of the fire pit. The 7” frame clearance allows for the screws securing the cradle brackets. Each
cradle bracket can be adjusted 1/2” from the top edge of the cradle or lowered to a total of 2 3/4” from the top edge of the
cradle. There are 1/4” increments to adjust the depth of the fire pit to fit most finishing materials (See Fig. 4.).
3) Pilot Covers - are decorative spacers that provide equal spacing for all models. One side is used as a pilot shield for
the pilot system in the Thermocouple Flame Sense (TFS) models.
4) Burner Trim (Optional) - is 5/8” deep and sits inside the cradle. It has a 3/4” lip around that overlaps the entire perim-
eter of the of the cradle for its finished look.
PART IDENTIFICATION & INSTALL DETAILS
Fig. 3 Part identification
Fig. 4 Cradle bracket depth alignment
2 ¾”
1/2”
Cradle
End View
¾”
1”
1 ¼”
2”
2 ¼”
2 ½”
2 ¾”
Valve Box
Only one screw
required at each end of
cradle brackets
TFS Linear Fire Pits
