Fired Up Corporation PO-E03, Инструкция по эксплуатации

Страница: 4 / 12

0 4
Installation
1. Remove Protection Baffle (5.)
2. Insert the gas cylinder (6) from the rear of the heater, and refit
Protection Baffle (5), making sure the cyclinder doesn’t move.
3. Ensure the regulator (4) is set with the gas valve in START position,by
turning clockwise.
4. Fit the regulator over the gas cylinder by depressing the release
button, and pushing onto the top of the cylinder.
5.Ensure the regulator is fully sealed then release the button to lock in
place.
6. If the gas cylinder has a separate valve, ensure this is open for use
and closed after use.
7. Only operate the heater in the UPRIGHT position, and the heater must
not be exposed to any sources of water.
Connect to Gas
Cylinder
Press to release clasp
Hose
Clip
Twist Valve to Open
Hose
4. Gas Regulator
WARNING - IF OUTSIDE, FRESH AIR VENTILATION IS NOT PROVIDED,
CARBON MONOXIDE POISONING COULD OCCUR