Fireco Dorgard X2, Руководство по монтажу и эксплуатации

Страница: 14 / 36

Flat Floorplate
IMPORTANT: Fit Dorgard X
2
to a door before
fitting the Flat Floorplate.
Warning! Before drilling holes or fastening Screws
into the floor, check the location of water pipes,
electrical cables, gas pipes etc. Failure to do so could
cause disruption to the building’s services and may
result in serious injury or death.
1. Open the fire door to 90 degrees or to the desired open
position greater than 65 degrees. Slide the Flat Floorplate
under the fire door.
2. Depress the Plunger on Dorgard X
2
so that the Ferrule sits
in the recess of the Flat Floorplate.
3. Slide/swivel the Flat Floorplate ensuring that the Ferrule is
still sitting centrally in the recess of the Flat Floorplate.
4. Mark the position of the Flat Floorplates holes on to the
floor surface. When fitting to carpeted floors, trim around
the hole position to prevent the carpet pile being pulled by
the spinning drill bit or Screw.
5. Remove the Floorplate.
6. If the floor is concrete, drill 4 x 6mm holes (approximately
40mm deep) at the positions marked and insert the Rawl
Plugs supplied.
7. Position the Floorplate over the Rawl Plugs or marked
points and fasten the Floorplate to the floor using the
Black Screws supplied.
8. Open the fire door and depress the Plunger. If you have
positioned the Floorplate correctly the Ferrule should fit
neatly into the recess of the Floorplate. If not go back to
step 3 and reposition the Floorplate.
13