Firechief Stove Guard FSG 1, Инструкция по установке и эксплуатации

Страница: 15 / 24

USER GUIDE 15
ACTION IN THE EVENT OF AN ALARM
P. 6-7 P. 8-9
The cooker will automatically be ready for use after the Stove Guard has detected that the
hazardous situation is over, and all the controls are set to “0”.
See the alarm overview below for actions.
SOUND MEANING MEASURES
Heat Sensor
4 “beeps” with a 1-second interval.
Dislocation Alarm
The Heat Sensor is removed
from the installation plate.
Return the Heat Sensor to the installation plate with the LED facing
the user.
Heat Sensor
Short “beeps” with
5-second intervals.
. . .
Pre-Alarm
The Heat Sensor sounds an
alert to warn user of danger
before disconnecting the cooker.
If the pre-alarm is triggered during normal cooking: press the Heat
Sensor button once while the pre-alarm sounds. The alarm will be
turned off and the sensitivity adjusts slightly, to suit your cooking style.
Heat Sensor
Many quick “beeps” followed by a
long, very loud sound.
. . .
! ! ! !
Switch-off Alarm
The cooker is switched off.
Make sure that the controls are set to “0”. Press the Heat Sensor
button once to return the power to the cooker.
Control Unit
Short “ring” with 5-second
intervals.
No power
The power to the
cooker has been cut off.
Make sure that the controls are set to "0". Wait until the cooker has
cooled down after it has been disconnected then press the Heat Sen-
sor button once to return the power. If the cooker cannot be switched
back on, see FAQ, question 9, page 19.
Control Unit
Continuous "rings".
No power
The cooker is too hot for the
power to be turned back on.
Make sure that the controls are set to "0". Wait until the cooker has
cooled down and the Control Unit starts emitting a short "ring" with
5-second intervals as described in the section above, or press the Heat
Sensor button once to reconnect the cooker. If the alarm does not stop,
follow the instructions on page 19, FAQ question 9, and press again.
Control Unit
Short and long “ring” with 10-sec-
ond intervals.
No power due to
Auto-diagnostics Alarm
The cooker has been discon-
nected due to a temporary fault
(automatic error diagnosis).
Make sure that the controls are set to "0". Wait until the cooker has
cooled down after it has been disconnected then press the Heat Sen-
sor button once to return the power. If the cooker cannot be switched
back on, see FAQ, question 3, page 18.
Heat Sensor
One “beep” per minute.
Or
Control Unit
One “ring” per minute.
Battery Alarm
The Heat Sensor has a low
battery.
The Heat Sensor battery is low and needs to be replaced. Pressing the
button once at this time delays the alarm for at least 12 hours.