Mounting the Fire Cam BlackJack Holder
With set screws loose, fit the BlackJack mount on the right or left brim of the fire helmet. It can
be installed above the brim or below the brim depending on the view from your camera. Snug
the 2 set screws on the brim BEING CAREFUL NOT TO OVER TIGHTEN. Place the camera
inside of the BlackJack mount making sure the button is on the top and camera is level. Tighten
down the set screw to hold the camera BEING CAREFUL NOT TO OVER TIGHTEN. If the set
screw starts to make marks on the camera, this will not damage the integrity of the unit. A small
piece of black tape can help limit the marks.
WARRANTY / DISCLAIMER:
Abuse of Camera IS NOT covered under warranty. Fire Cam warrants its products against
defects in material or workmanship for 12 months from date of purchase unless otherwise
specified. This warranty also includes the "Fire Cam Damage" warranty. If the cameras
components get damaged in a fire, you are covered for one free replacement. The Fire Cam 4K
Fire Helmet Camera
’s warranty is limited to the replacement or repair of the defective item at no
charge if we determine the item to be defective. This warranty shall not apply to any item
subject to misuse including such as failure by buyer to follow instructions, product modification,
normal wear and tear, negligent or improper operation. Abuse of camera, cable or accessories
IS NOT covered under the warranty. Fire Cam products are not recommended for concrete
training towers or flashover chambers where it could sustain high temps for long periods of time.
Electronic damage due to over-voltage, incorrect polarity from product power supplies, or
incorrect MAINS voltage is not covered under the warranty. DO NOT USE ANY
AFTERMARKET CHARGERS FOR YOUR CAMERAS. Fire Cam chargers are designed
specifically for Fire Cam
’s only. Modification, repair, or attempted repair by anyone other than
Fire Cam or without the written permission of Fire Cam will void this warranty. This warranty
covers the cost of factory repair, labor and parts on eligible equipment which is returned.
Equipment, which is repaired under this warranty will be returned freight prepaid. If it is
determined that the Fire Cam does not need repair, the purchaser shall pay for return shipping
charges. Disclaimer: Fire Cam does not assume any responsibility for any accidents or injuries
incurred to the user of the Fire Cam Fire Helmet Camera.
WARNING!
Firefighting is a dangerous activity and should only be performed by a trained professional. The
end user of Fire Cam products assumes all responsibility connected with the use of this product
including but not limited to continuing education, and activity that conforms to local Standard
Operating Procedures. Neither the manufacturer nor any distributor assumes any liability for
injuries sustained while using Fire Cam products. The Fire Cam® Fire Helmet Cameras TM are
manufactured of anodized aluminum, and may retain heat for several minutes after being
exposed to a heated environment such as a structure re or training re so it needs to be handled
with care. The end user is responsible for installation consistent with the mounting instructions,
as well as regular safety inspections of the BlackJack Holder and Fire Cam Fire Helmet
Cameras. For further questions, please go to
www.FireCam.com
under the "contact us" page.
Содержание 1080 WIFI
Страница 1: ...Fire Cam 4K User Manual...
