Fire Sense PH01-S XL Series, Инструкция по эксплуатации

Страница: 7 / 23

7
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package
contents list as listed on page 5 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME
: 60 minutes
Tools Required for Assembly (Included)
Open end wrench 10mm and 13mm
Tools Required for Assembly (NOT included):
Philips screwdriver w/medium blade
Leak Test Solution
(one part liquid dishwashing detergent and three parts water)
Adjustable opening wrench, 8" long
Other items required for assembly :
 AAA Battery : This heater has a Rapid-Spark Electronic Ignition system and will require installation of
1) AAA battery. (NOT INCLUDED) The battery should be installed by unscrewing the RED IGNITER
BUTTON on the front of the burner head assembly.
Once the battery has been installed please test the ignition system by briefly pressing the red igniter
button. If you hear a rapid series of sparks your Rapid-Spark Electronic Ignition system is working
properly. If you do not hear any sparks please check to make sure the battery in installed in the correct
direction and that it is fresh and fully charged.
Otherwise please refer to the troubleshooting guide on page 21 of this manual for further assistance.
 Sand (25 Lbs) for filling the Sand/Waterbox : Your Fire Sense XL Series patio heater comes standard
with an empty PVC Sand/Waterbox container which is pre-assembled to the heater base. Once filled with
sand, this weighted container will add approximately 25 lbs. to the base of the heater providing extra
stability and safety.
Tip: When filling with sand, having a funnel on hand will be helpful. If possible, use easy-to-pour, dry
silica sand (available at most home improvement centers.)
Note : The Sand/Waterbox container may also be filled with water (mild weather climates) or automotive
windshield washer fluid (cold weather climates) however, the additional weight when filled with water or
windshield washer fluid will only add approximately 18 lbs. to the heater base as compared to the 25 lbs. when
filled with sand.
Tip: To add an additional 5-6 lbs. of weight to a sand filled base, add water (mild weather climates) or windshield
washer fluid to the base after filling it with sand.
ASSEMBLY