14
Document 50400 Rev B 10/27/97 P/N 50400:B
Semi-flush Mount Backbox
Remove the plug-in terminal blocks from the LED-10 Series circuit board. Connect the
EIA-485 and power wiring into the terminal block positions illustrated in Figures 3-1 and
3-3. Plug the terminal blocks back into the TB1 and TB2 connectors on the back of the
annunciator circuit board.
Set DIP switches SW1 and SW2 for the desired options (refer to switch settings in
Figures 1-3, 1-4 and Table 1-1).
Mount the LED-10 Series to the three-gang electrical box using the four mounting holes
on the annunciator flange and the four screws provided for this purpose. Replace the
trim ring and secure with the two screws which were previously removed. Adjust the
plastic trim ring to the surface of the wall before tightening the screws.
Do not over-
tighten.
Figure 2-3: Semi-flush Mounting
LED-10 Series flange
Mounting Holes (4)
Three-gang electrical box
(Fire•Lite P/N 10103 or equivalent
with 2 3/16" minimum depth).
flange
EIA-485 and power wiring
LED-10 Series
Содержание LED-10 series
