Fire-Lite IPDACT, Руководство по установке

Страница: 32 / 51

IPDACT Module - Configuration
IV-29
Doc. Dm373-I
Rev. 2.0
enabled. To enable/disable the client, enter the IPDACT generic
configuration:
-- Generic MIP config --
IP Connectivity
a) DHCP client: OFF
b) IP addr: 192.168.0.202 msk: 255.255.255.0
c) Gateway IP: 192.168.0.250
User Access Control
d) Password: 1234
Miscellaneous
e) Date & time: 01/16/1980 17:37:28
f) Events: PHON RMON CID RALA RCFG
g) PC verifying digit: OFF
z) Exit
option:
In the DHCP client section, you can configure the client as enabled/disabled.
option: a
DHCP client: (0:OFF - 1:ON)
IV - 3. Telephonic Console
In order to use the telephonic console, a normal analog telephone connected
to the choc blocks labeled TO-AP is required. This telephone must be
configured to dial through tones. These choc blocks are used to connect the
IPDACT to the control panel consequently the telephonic console is not
always available and it’s necessary to activate it.
To activate the telephonic console, short circuit the P1 jumper in board
versions up to 4 and P2 in board version 5, for a little more than a second with
some metallic element. You can use a small screwdriver or a simple clip.
During this process the telephone must be on hook. On activating the
console, if the telephone relays are inactive (line status LED off), they activate
(i.e. the LED lights up); if they are already active, they will briefly deactivate to
indicate that the telephonic console is available.
On picking up the phone, you will hear an intermittent tone which requires you
to introduce an access password. In order to introduce the password, you
need to press “**#” (asterisk, asterisk, pad) and the access password. By
default the access password is
24680 . If this is correct, you will hear three