Fire dept GD5, Руководство по установке

Страница: 7 / 27

Version: June 2018
6
Burner Tray Installation Process
LPG Natural Gas
GD5 1200
Input 18-26 MJ/h
One gas injector at the
pilot side of the burner tray.
•
Install the burner tray by carefully lowering the end
opposite from the pilot meanwhile holding up the
pilot end, lower the burner tray down and move
towards the pilot in one movement.
•
Ensure the burner tray is located correctly into the
burner bracket and the jets are aiming into the
burner tube inlet holes.

Install the burner tray by carefully lowering the end
opposite from the pilot meanwhile holding up the pilot
end, lower the burner tray down and move towards
the pilot in one movement.
• Ensure the burner tray is located correctly into the
burner bracket and the jets are aiming into the burner
tube inlet holes.
• On the pilot side gas injector, gently tighten (do not
over tighten) the 12mm brass nut closest to the
burner tray .
GD5 1400
Input 20-28 MJ/h
Two gas injectors one at the
right and one at left hand
sides of the burner tray.
GD5 1600
Input 30-38 MJ/h
Two gas injectors one at the
right and one at left hand
sides of the burner tray.

Install the burner tray by carefully lowering the end
opposite from the pilot meanwhile holding up the
pilot end, lower the burner tray down and move
towards the pilot in one movement.

Ensure the burner tray is located correctly into the
burner bracket and the jets are aiming into the
burner tube inlet holes.
• Install the burner tray by carefully lowering the end
opposite from the pilot meanwhile holding up the pilot
end, lower the burner tray down and move towards
the pilot in one movement.
• Ensure the burner tray is located correctly into the
burner bracket and the jets are aiming into the burner
tube inlet holes.
•
On the non pilot side injector, gently tighten both the
12mm brass nuts. The injector will pull towards the
burner tray.

On both the non-pilot and pilot side gas injectors,
gently tighten (do not over tighten) the 12mm brass
nuts closest to the burner tray.
Cover and end cap installation
GD5 Pilot ladder rope
This model has ladder rope
under the pilot end burner
end cap.

Ensure the insulating material is glued to the end cap fixing panel
and runs behind the 3 way pilot, rectifier and sparker probes.
GD5 Pilot cover
This model has one pilot
cover.
•
Replace the stainless steel pilot cover (2 x screws) at the pilot end
of the burner.
GD5 Burner end caps
This model has two end cap
covers, One at each side of
the burner
•
Replace the stainless steel burner end caps (3 x screws on each cap)
at either end of the burner.
Non-pilot side Gas Injector Pilot side Gas Injector
Insulating material
Pilot cover
Non pilot burner end cap Pilot burner end cap