Fire dept GD13, Руководство по установке Инструкции по эксплуатации Гарантия

Страница: 8 / 17

Version: June 2019
8
Step 5: Connect and test electrical supply
•
All electrical connections must meet the requirements of AS/NZS 3000 standards and be installed
and certified by a suitably qualified person.
•
The appliance is supplied with 1000mm of 3-core cable to a 3 pin plug that will plug into the electrical wall
socket (electrical wall socket not supplied).
•
The appliance can also be hard-wired into the building if required.
•
In order to access the electricals, it is necessary to first remove the front cover.
•
Follow the ‘
Front Cover Removal P
rocess’
in this guide.
•
With the front cover removed the electrical connections in the appliance can be seen.
•
Following these connection details, using the 3-core cable from the appliance, remove the 3-pin plug and
hard wire the cable into the building.
•
IMPORTANT: Before testing, ensure the gas valve is turned off.
•
GD13 models have a glass failure safety switch at the base of the
opening. The safety switch turns the appliance off if the glass is not in
position. The 3mm pin will need to be held down to complete electrical
testing. It is recommended that masking tape is used to hold the safety
pin down.
NOTE : The masking tape must be removed once testing is completed.
•
Test electrical functions by switching the bottom High/Low switch to LOW, then switch the appliance ON
using the top On/Off switch.
•
The fan will start and after approximately five seconds, the pilot will spark. Because the gas supply is turned
off, the pilot will spark for approximately five seconds then automatically switch off. The fan will continue to
operate.
•
NOTE: GD13 models have a fan which operates in both LOW and HIGH settings.
•
Switch to HIGH setting. Ensure that a red light appears on the electrical connections block and the fan is
operating.
•
Switch the appliance off. Electrical testing is complete.
•
Fit the front cover by following the
‘Front Cover Installation Process’
in this guide.
Safety switch pin