EN
6
3.3 Drive Engaged
Refuel the machine (see next paragraph).
Switch on the machine and move it by means of its
hydraulic drive (see next paragraph).
Carefully move it down from the packaging
platform.
The machine can be moved with its drive only if
unpacked outdoors.
4 Commissioning
4.1 Fuelling
Turn off the engine.
If present, remove the waste container from the
back side of the machine (see next paragraph).
Unscrew the tank cap.
Top up with suitable fuel (see engine use and
maintenance manual)
Fill the tank up to 2.5 cm below the top edge of the
filler neck.
Eliminate any spilled fuel and close the tank cap.
4.2 Control interventions
For the execution of the following controls refer to
the chapter entitled
"Care and maintenance"
.
Check the motor oil level.
Check the level of fuel tank.
Check the level of the hydraulic oil.
Empty the waste container.
4.3 Positioning the Waste Container
To insert and remove the waste container
according to DIN EN 840-1, lift the suction head.
Press the specific switch on the
dashboard to move the head.
The head can only be enabled electrically
with the ignition key ON.
The head cannot be lifted or lowered with the
engine running. The engine can only start if the
head is properly fit on the waste container. In any
case the waste container must be positioned with
the engine off.
WARNING
Place the appliance on a level
surface.
HAZARD
Risk of explosion.
•
Refuel only with the engine off.
•
Only use the fuel stated in the engine
operating instructions.
•
Do not refuel in closed
environments.
•
Do not smoke or use naked flames.
•
Make sure that the fuel does not come
into contact with hot surfaces.
WARNING
The waste container must be positioned
with the engine off.
HAZARD
WARNING
WARNING
