Fintek SANTIAGO, Инструкция по установке и эксплуатации

Страница: 34 / 48

8
2.INSTALLATION ENGLISH
To fit the external two grating please proceed as
follows: familiarise yourself with the fitting of the
grating to the tube, before installation. Insert the
cords through the centre of the grating. One
grating fits on the outside of the tube and the other
fits inside. The air discharge is the bigger hole and
the grating therefore fits on the outside of the air
discharge tube. Insert the supplied cord into the
hole. Fold the outer grating in half grasping the
cord with your free hand. Insert your arm inside the
pipe with the grating and push all the way to the
outside. Let the grating unfold and pull the cord
toward you. One grating fits on the outside of the
tube and the other fits inside. With a little patience
and mainpulation the 2 gratings will fit the end of
the tubes. Grasping the cord, insert your fingers
between the fins and pull the grating toward you
until the same is properly slipped in the pipe,
keeping the fins in vertical position. If the external
grating is accessible to prevent its removal, it is
recommended to fasten it to the wall with wall
plugs and screws with a diameter of 6mm. Tighten
the cord and fasten it to the dent on the internal
flanges.
2.6 FITTING THE GRATINGS
(P7,P8,P9,P10)
P7
P8
P9
P10
34 SANTIAGO