FINO
®
Installation, Operation & Maintenance Manual
7
RVRV
A. Installation
This controller is installed inside the steam room only, and it comes
with a built-in temperature sensor. The best location for the control is
close to your bench for easy access, also further away from steam
head. It is recommended to install the control pad from 36" up to the
maximum 48" height.
Note:
The controller is provided with a 25 ft standard-length connector
cable. If you need to extend up to 50 ft, use 4-core wires (22 to 18 AWG).
B. Operation
Programme for temperature setpoint and time setting.
1.
Power Sign
: Turns on or shut off the steam. When the control is in standby mode, the power
light stays on.
2.
Temperature control
: Controls the temperature set point in the steam room, which can set
from 10°C(50°F) to 85°C(185°F). To change the temperature setpoint, just touch the
TEMP
sign for 3 seconds, while the control is on, then use the
▲
(Up) or
▼
(Down) to set it to desired
value (hold it to change faster), touch the
ENTER
to save it.
3.
Time control
: Controls the duration of steam operation, which can be set from 5 to 90
minutes in 1-minute increments. The unit will work until it times out. To change the time
setting, Touch the
TIME
sign for 3 seconds while the control is on, then use the
▲
(Up) or
▼
(Down) to set it on desired time (hold it to change faster), touch the
ENTER
to save it.
4.
Temperature/Time display
: When the control is turned on, it displays the current
temperature in the steam room; By simply touch the temperature / time sign to switch the
display on temperature or time. On the time display, it will show the minutes counting down.
5.
Celsius to Fahrenheit:
To switch the display reading between Celsius and Fahrenheit, first,
turn off the control. Then touch the
TEMP
sign until the "F" or “C” turns on the display.
6.
Lights (LEDs)
: There are 5 lights around the
display, each indicating a status:
-
Power:
is on as control is off in standby mode.
-
TEMP:
is on when there is a call for steam.
-
TIME:
is on when timer is still counting down.
-
°c:
is on when temperature is set for Celsius.
-
°f:
is on when temp. is set for Fahrenheit.
7.
Default Setpoints:
The control goes back to the
following default settings if the power is interrupted.
Temperature defaults: 47°C (117°F).
Set range: (10 to 85°C)/(50 to 185°F).
Time default: 30 minutes.
Set range: 5 to 90 minutes.
FiNO Control - Glass Touch
