Finn T120-II HydroSeeder, Инструкция оператора и каталог запасных частей

Страница: 40 / 139

34
REGENERATION (CONTINUED)
RECOVERY REGENERATION (CONTINUED)
Note:
Recovery Regeneration will not begin if any of the following conditions are present:

Coolant temperature is less than 60° C (140° F)

The engine has not been running for 15 minutes

An important DTC is active

The interlock switch is off (pump clutch is engaged) or if the hydraulic system is on

Idle speed is too high
If these conditions are present, a notification will be displayed. Once these conditions are
corrected by the operator, acknowledge the message and Stationary Regeneration will begin.
6. At this point, the ECU will take over control of the engine to perform the Recovery
Regeneration and a notification of “Recovery Active” and the regeneration icon will be
display along with a status bar (0 to 3 hours) at the bottom of the screen.
Note:
When the Recovery Regeneration starts, the engine speed increases gradually to high
idle speed, then the regeneration begins and may modulate engine speed throughout the
process.
Note:
If Recovery Regeneration needs to be interrupted for any reason, turn off the key
switch. One the machine is restarted, the Recovery Regeneration request will be
repeated.
7. If the Recovery Regeneration is
successful, a notification will be
displayed and the engine will return
to low idle, but will not automatically
turn off. Normal machine operation
can resume.
8. If the Recovery Regeneration is
not successful, a notification will be
displayed. Stop the engine and see
a Yanmar certified service center for
a Soot Filter exchange.
There are 2 ways out of Limp Home:
1. Perform a Recovery
Regeneration
2. Perform a Soot Filter exchange
with SA-D