Finn BarkBlower BB-1208 MS, Руководство по эксплуатации и каталог запасных частей

Страница: 10 / 77

4
III. MAINTENANCE:
1. Before servicing the
machine, turn off engine
and allow all moving parts
to stop. To prevent acciden-
tal starting, disconnect bat-
tery cables. Tag the engine
operating area to show that
the machine is being ser-
viced. Use lockout/tagout
procedure (OSHA 29 CFR 1910.147).
2. Take extreme care when
adjusting or replacing
knives. Knife edges are
very sharp and can cause
severe bodily injury.
3. Radiator maintenance: Liquid cooling systems build
up pressure as the engine gets hot. Before removing
radiator cap, stop the engine and let the system cool.
Remove radiator cap only after the coolant is cool.
4. Battery maintenance: Lead-acid batteries contain
sulfuric acid, which will damage eyes or skin on con-
tact. Always wear a face shield to avoid getting acid
in the eyes. If acid contacts the eyes, flush imme-
diately with clean water and get medical attention.
Wear rubber gloves and protective clothing to keep
acid off skin. Lead-acid batteries produce flammable
and explosive gasses. Keep arcs, sparks, flames,
and lighted tobacco away.
5. Filling of fuel: Never fill the tank with the engine run-
ning, while smoking, or when near an open flame.
Never smoke while handling fuel or working on the
fuel system. The fumes in an empty fuel container
are explosive. Never cut or weld on fuel lines, tanks
or containers. Move at least 10 ft (3 m) away from
fueling point before starting engine. Wipe off any
spilled fuel and let dry before starting engine.
IMPORTANT: Be careful not to allow fuel, lubricant,
hydraulic fluid, or cooling fluids to penetrate into
the ground or be discharged into the water system.
Collect all fluids and dispose of them properly.
6. It is recommended that only authorized, genuine
FINN replacement parts be used on the machine.
7. Do not use either cold start fluid, if engine is
equipped with glow plug type preheater, or other
intake manifold-type preheater. It could cause an
explosion or fire and severe injury or death.
8. Diesel fuel or hydraulic fluid
under pressure can pen-
etrate the skin or eyes and
cause injury, blindness, or
death. To check for such
leaks, use a piece of card-
board or wood instead of
your hand. Pressure may
build up in the hydraulic
system; use caution when
removing the cap.
9. Some parts and assemblies are quite heavy. Before
attempting to unfasten any heavy part or assembly,
arrange to support it by means of a hoist by blocking
or by use of an adequate arrangement to prevent
it from falling, tipping, swinging, or moving in any
manner. Failure to do so could result in component
damage, or physical injury to someone.
10. If repairs require use of a torch or electric welder, be
sure that all flammable and combustible materials
are removed. Fuel or oil reservoirs must be emptied,
steam-cleaned, and filled with clean water before
any cutting or welding on them is attempted. Do
NOT weld or cut on any tank containing oil, gasoline,
fumes, other flammable material, or on any container
of which the previous contents were unknown.