Finlux FXVT 60, Инструкции по эксплуатации и монтажу

Страница: 12 / 48

Turn On and Turn Off The Appliance
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button at least 1 second. A buzzer signal indicates the successful
operation acoustically.
On all heaters a ´0` appears and all Decimal Point of the heater flashes (1
sec on, 1 sec off).
If there is no operation within 10 sec, the display of all heaters will turn off. If
the displays are turned off, the heater will be set into Stand-By-Mode .
If is pressed more than 2 sec (in Operating-Mode ), the appliance is switched
off and is set into the S-Mode again. The appliance can be turned off by
pressing at any time; even if other buttons are pressed simultaneously.
If there is a residual heat of a heater remaining, this will be indicated in the
correspondent heat setting Heater Display .
Select Heater
If a single heater is chosen with the corresponding Active/Deactive Heater
Button , the Decimal Point of the related Heater Display flashes. For the
selected heater, you can set the heat level between 1-9 by touching the Heat
Setting Buttons or .
The buttons must be pressed within 3 sec, otherwise the heater selection is
erased and heat setting dot will disappear ( Decimal Point ). If there is no further
operation within 10 sec, the heater falls back into the S-Mode .
The heat setting can always be changed by pressing or between level
1-9.
Each button operation or each display change is quitted by a buzzer signal.