Finlux 24FLHYR910LVHU, Руководство пользователя

Страница: 54 / 86

English - 53 -
HDMI
1
SPDIF
Coax.OUT
External device
(not supplied)
HDMI Cable
When you connect to DVD player as illustrated above, •
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable
Some DVD players are connected through •
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
When the connection is made, switch to YPbPr
•
source. See, “Input selection” section.
To enable audio connection, use the
• VGA/
Component Audio cable . First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player’s audio cable’s connectors into the plural part
of the
VGA/Component audio connection cable
( see illustration below ). Colours of the connected
jacks should match ( RED & WHITE).
AV Connection
Cable (supplied)
Audio Cable
(not supplied)
To DVD Player's
Audio Outputs.
SIDE
AV
When the connection is made, switch to • YPbPr source.
See, Input selection section.
You may also connect through the • SCART input.
H
DMI
1
SPDIF
Coax.OUT
Scart Cable
(not supplied)
External device
Note • : These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of •
the handset by gently pulling backwards from the
indicated part.
Insert two
• AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note : Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220 - 240 V AC 50 •
Hz. Then the standby LED lights up.(The led will
blink during the standby On/Off)
To switch on the TV from standby mode either:
•
Press the “ • ” button, P+ / P- or a numeric button
on the remote control.
Press the “ • ” button, - or + button on the TV. The
TV will then switch on.
02_MB60_[GB]_5110UK_PVR_DVB-TC_BRONZE17_woypbpr_224910LED_10077018_50208743.indd 53 02_MB60_[GB]_5110UK_PVR_DVB-TC_BRONZE17_woypbpr_224910LED_10077018_50208743.indd 53 06.01.2012 15:10:51 06.01.2012 15:10:51