Page 9
Multi-Lid Directions
1. Open fill cap and place garden hose into tank. Fill tank to desired gallon marker, if marker
is above the bottom of calibration container, stop before water reaches calibration
container. This is done to help chemical mix better and keep foaming of chemical to a
minimum later.
2. Remove Multi-Lid and use calibration container to measure the correct amount of chemi-
cal for the water being used.
3. Pour chemical into tank and tighten Multi-Lid back onto tank. If desired amount of water
was added in step 1, you are done. Be sure to press firmly on fill cap to seal with Multi-
Lid. If desired amount of water was not met in step 1, proceed to step 4.
4. Open fill cap and place garden hose into tank. Add water to the desired gallon marker.
Close fill cap, pressing firmly to seal cap to Multi-Lid.
NOTE: If water and chemical has not mixed properly, use the pressure adjustment control on
the manifold to recirculate the mixture through tank.
34½”
16¾”
47”
34½”
36”
Technical Specifications
Properly secure the tank to your utility vehicle, using tie-down or ratchet straps (Not Included).
Tank straps may be installed through the handles to help prevent straps from slipping off tank if too loose.
Handles can be used to lift the empty tank in and out of the box.
Stay within your utility vehicle’s weight limits. This unit when filled with water weighs approx.: 650 lbs.
Consult the owner’s manual for your vehicle.
UTV Intake
Plumbing
(5281072)
Refer to Parts
List Page 7
for Part Numbers
Intake Detail
Ref. #2 is found inside
of the tank
