Fimap BMg 50 Orbital, Руководство по эксплуатации и обслуживанию

Страница: 42 / 52

CLEANING THE DETERGENT TANK (FSS VERSIONS)
Clean the detergent tank before a long period of non-use of the machine:
1. Press the recovery tank release lever (1) and turn the recovery tank into the maintenance position (
Fig. 1
).
2. Disconnect the male insert (2) from the female insert (3) on the cap of the detergent canister ( Fig.2 ).
N.B.: before pulling on the male insert, push the lever on the female insert.
3. Grip the handle on the detergent canister (4) to remove it from the compartment in the solution tank (
Fig.3
).
4. Remove the cap (5) from the detergent canister ( Fig.4 ).
5. Rinse the inside of the canister with a jet of running water.
6. Make sure you tighten the cap (5) properly to avoid any leakage of liquid while working. Make sure the detergent suction filter (6) is correctly
positioned on the bottom of the canister ( Fig.5 ).
7. Grip the canister handle to replace the canister in its compartment inside the solution tank.
8. Connect the male insert to the female insert in the cap of the detergent canister.
9. Rotate the recovery tank into the working position ( Fig.6 ). Make sure that the recovery tank retainer system is correctly engaged.
2 4 5 3
5
6
4
3
2
6 1
1
REPLACING THE SQUEEGEE BODY RUBBER BLADES
Ensuring the integrity of the squeegee body's rubber blades guarantees better floor cleaning and drying results, as well as a longer service life
for the suction motor. In order to replace the squeegee body's rubber blades, do the following:
1. Extract the vacuum hose (1) from the vacuum nozzle on the squeegee body ( Fig.1 ).
2. Completely unscrew the knobs (2) in the squeegee body's pre-assembly ( Fig.2 ).
3. Remove the squeegee body from the slits in the squeegee connector.
4. Remove the rear rubber blade compression plate, and release the stopper (3) at the rear of the squeegee ( Fig. 3 ).
5. Remove the rear rubber blade (4) from the squeegee body ( Fig. 4 ).
6. Completely unscrew the knobs (5) in the squeegee body pre-assembly ( Fig.5 ).
7. Remove the front rubber blade (6) from the squeegee's internal body ( Fig. 6 ).
8. Repeat the operations in reverse order to reassemble all the parts.
N.B.: Before using the machine, remember to adjust the squeegee body: see the section titled “ ADJUSTING THE SQUEEGEE BODY'S
RUBBER BLADES ”.
N.B.:
It is recommended to replace both squeegee body blades in order to ensure good results when drying the floor.
6
6
3
3
5 4
4 5
2 1
1 2
EXTRAORDINARY MAINTENANCE
Before carrying out any extraordinary maintenance operations, proceed as follows:
1. Take the machine to the maintenance area.
N.B.: the place given over to this operation must comply with current environmental protection regulations.
2. Make sure the machine is in a safe condition (see chapter “ MACHINE SAFETY MEASURES ”).
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
42