FilterWater.com
800-439-0263
Copyright
©
2008 filterwater.com
http://www.FilterWater.com
The System Set-up and Preparation Instructions
Adjust the cold water supply lie at the T-Valve by slowly turning the handle counter-clockwise to
reduce flow to the System.
1.
Connect the water supply line tubing to the System access board labeled “water inlet”
2.
Turn the cold water supply line on again. Make sure there is no leak at the connection.
3.
Turn the shut-off valve handle to the “ON” position to allow the cold water flow thru the System.
Check that water flows through the cold faucet.
4.
Check all connections including the filters and all other tubing and fitting connections inside the
System for possible leaks.
5.
Dispense water from the hot and cold water faucet/spouts and run water until water flows freely and
there is no more air in the line.
6.
Allow water to flow thru the System to refill the cold and hot tanks.
7.
Make sure to flush filters/membranes.
8.
Plug the power cord into a receptacle outlet. Make sure the System is plugged into a 115 volt
grounded outlet which contains a fuse or circuit breaker of 20 amps or less.
9.
Turn on the hot and cold tank switches.
10.
Do not use the first three reservoirs of water; these are meant to flush the System.
11.
Recheck the System for water leaks.
