FILM LIGHT Truelight SDI, Руководство пользователя

Страница: 26 / 36

Chapter 4 – Operation
Remote control
Truelight SDI User Guide
22
The Legalizer , Bypass , Scaling and Panel Lock buttons have the following functions:
Test signals
This panel controls the built-in test signal generator:
The Test signal enable button toggles the test signal generator on and off. Test signals are
selected by clicking on the appropriate button. Some of the signals take the values entered
into the Red, Green, and Blue boxes. See
page 15 for details of the test signals available.
Stopping the
remote control To stop the remote control applet, simply close the browser or navigate away from this
page. Note that if you return to the remote control applet you will need to enter the
password again.
Button Description
Legalizer Options are OFF or Hard clip . When set to Hard clip, the output from the unit is clipped
at the 64-940 (10-bit) range. This applies to both RGB and YUV output modes. Note that
the legalizer cannot be enabled if Scaling is on.
Bypass When enabled the unit is placed into bypass mode.
Scaling Use this mode if your input data is limited to the legal 64-940 range. Internally, the unit
will stretch this range to the full 0-1023 range available in the cube. On output, the 0-
1023 values are scaled back down and offset to give the correct 64-940 range. Note that
any input values outside the 64-940 range will effectively be clipped.
Panel Lock When enabled, the front panel buttons on the Truelight SDI unit are disabled preventing
local operation. In this state, the message ‘PANEL LOCKED’ appears in the LCD.
Figure 4-4: Test signals