Basic Operation
3
•
Turning The Light On
Insert the PowerCon Cable of the external Power Adapter into the PowerCon
Connection Port (19) and rotate clockwise to lock in place. Plug the light into an
appropriate outlet. The On/Off Button (20) will light red to signify it is in stand-by
mode. Press the On/Off Button (20) to turn on the light. The On/Off Button (20) will
light green to signify it is in working mode.
•
Positioning The Q1000
To adjust the Q1000, grasp the Handles (11) then loosen the Tilt Lock Lever (10).
Adjust the angle to the desired position then tighten the Tilt Lock Lever (10) to
secure.
•
Adjusting Beam Angle
Adjust the beam angle by turning the Focusing Knob (6). The lens tube will extend,
moving back and forth from the lamphead housing.
•
Mounting The Q1000
The Q1000 can be mounted in a standing or hanging position with the Junior Pin
Receiver (7). In order to mount the light, insert the stud of the C-Stand into the Junior
Pin Receiver (7) and secure by tightening the Stand Locking Pin (8). When mounting
in a hanging position, secure the light with a Safety Cable (Not Included).
•
DMX Interface
The Q1000 is equipped with two DMX interfaces. RJ45 (23) or XLR ports (21&17) are
used to send the DMX signal to the lamphead. Both interfaces include in/out ports for
the purpose of daisy-chaining the DMX line through to the next lamphead.
•
USB Interface
The Q1000 is equipped with a Mini USB port for updating the Q1000's firmware.
Please register your product at www.fiilex.com to be informed when firmware
updates are available.
