Fieldmann FZS 70705-0, Руководство пользователя

Страница: 15 / 116

EN
CORDLESS BRUSH CUTTER USER'S MANUAL
15
Assembly
Notice: Install the right shaft following the switch handle label on the upper shaft. There are two long bolts
in the handle. Customers can matching it with the handle bolt hole.(See Fig. A2)
Fasten the dour wing bolts.Have a try to drag the handle, ensure the shaft is fi xed.( See Fig A3)
Notice: Operating the machine with the handles perpendicular to the shaft is only permitted.
2. ATTACHING THE SHOULDER STRAP
Put on the shoulder strap. (See Fig. B)
3. MOUNTING THE SAFETY GUARD
The sheet metal is preassemble.
Insert the sheet metal into the safety guard groove. (See Fig. C1)
Align the three bigger mounting holes in safety guard and shaft base. Lock the safety guard onto the shaft base
with screw bolt. Then align the side holes on safety guard and screw them fi rmly together with Hex wrench(21).
(See Fig.C2)
NOTE: When the tool is equipped with a trimmer head, make sure that the line cutter is on the safety guard.
4. FIX THE UPPER SHAFT AND LOWER SHAFT
- Loosen the clamp by turning the clamp knob counterclockwise.
(See Fig. D1)
- Align the shafts and insert the lower shaft into the upper shaft.
- Position the tube locking/release button (a) into the guide recess (b) of the clamp. (See Fig. D2)
- Ensure the locking button is engaged with the location hole in the clamp.
- Tighten the knob securely by turning clockwise. (See Fig. D2)
5. ADJUSTING CUTTING LINE LENGTH
The trimmer head allows the operator to release more cutting line without stopping the motor. As line becomes
frayed or worn, additional line can be released by lightly tapping (See. Fig. E1) on the ground while operating the
trimmer (See. Fig. E2)
Notice: Line release will become more diffi cult if the line cutter becomes too dull.
Notice: The original line length is 330mm. There are two kinds of cutting width When the line cutter is
mounted on the location as Fig. E3, the cutting width is 330mm. When the line cutter is mounted on the
location as Fig. E4, the cutting width is 380mm.
WARNING: Do not remove or alter the line cutter blade assembly. Excessive line length will be cutted to
suitable length.
6. REPLACE THE TRIMMER HEAD WITH THE 3-TEETH BLADE (THE TRIMMER HEAD IS FIXED IN
THE TOOL IN THE ORIGINAL PACKING )
Insert and keep the shaft lock rod into the hole of trimmer head and loosen the trimmer head by screwing it
clockwise. Take away the trimmer head. (See Fig. F1)
1) Stick the stop rod (22) into the hole on the side of trimmer head.
2) Loosen the trimmer head by clockwise.
3) Take away the trimmer head.