Fieldmann FZR 2110-LI, Руководство пользователя, Страница: 15 / 24

EN 16
Troubleshooting
FZR 2110-Li
8. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The handle is not in
the correct position The handle fi xing screws are not correctly
mounted.
The mower handle joining screws are
not tight.
Adjust the handle height and ensure that
the screws are correctly seated in the pre-
drilled holes.
Tighten the joining screws.
The mower does not
work. The battery is not connected to the
mower.
The safety fuse is not connected
The control trigger is defective.
Connect the battery and click it into place
Connect the safety lock
Have the engine control trigger replaced by
an authorized service centre.
The mower cuts grass
unequally. The lawn is ragged or bumpy.
The mowing height is not set properly. Check the mowing area.
Move the fl oat to a higher position.
It is diffi cult to push
the mower. The grass is long or the mowing height
is too low. Increase the mowing height.
The mower vibrates at
high speeds. The engine shaft is bent.
The blade is not balanced.
Stop the engine, disconnect the mower
from the power source and check for
damage. Repair the mower before starting
it again.
If vibration persists, contact a service
centre
Balance the blade evenly by grinding each
cutting edge.