EN
10
FZP 2020-E
5. INSTALLING THE GUIDE BAR AND CHAIN
ATTENTION!
The chain saw must be disconnected from the
power grid.
ATTENTION!
Always wear protective gloves when installing
and inspecting the chain to prevent injury from the
sharp cutting edges on the chain.
The safety brake lever (fi g. 1 point 5) must be
disengaged (pull it towards the top handle)
Loosen the sprocket cover fastening knob (fi g. 1,
point 7) and remove the sprocket cover (fi g. 1, point
10)
The wheel of the quick coupling system (see fi g. 2,
point 1) is already mounted.
If the guide bar is replaced, it is possible to remove
this wheel and mount it on the new guide bar
Seat the chain on to the guide bar; put the guide bar
with the chain on the guide bolt (fi g. 3, point 1) and
thread the chain on to the drive sprocket wheel (fi g. 3,
point 3)
Turn the wheel of the quick coupling system (fi g. 3,
point 2) to easily tension the chain.
Put on the sprocket cover and fasten it using the
sprocket cover fastening knob (fi g. 4)
Do not fully tighten the knob, it would not be possible
to tension the chain
Tension the chain using the tensioning wheel (fi g. 1,
point 6).
For tensioning it is necessary to hold down the
sprocket cover fastening knob (see fi g. 5)
ATTENTION!
The chain is correctly tensioned if it is possible
to lift chain off the guide bar and its height in the
horizontal position in the middle of the guide bar is
3 to 4 mm.
Installing the guide bar and chain
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Содержание FZP 2020-E
