Fieldmann FDW 202001-E, Руководство по эксплуатации

Страница: 17 / 178

EN
HIGH-PRESSURE WASHER OPERATING INSTRUCTIONS
17
19
USER‘S MANUAL HIGH-PRESSURE WASHER
EN Troubleshooting guide
Circuit breaker trips
or fuse blown in
fuse box Circuit overload Verify that the circuit is rated at 15 amps or
greater. Ensure no other appliance is drawing
power from the same circuit [dedicated
circuit).
Extensor Cord too
long or wire gauge too
small
Nozzle partially
blocked
We do not recommend using of extension
cords with your high-pressure washer. If
you must use an extension cord, verify that
it meets the minimum requirements listed
in the Extension Cord paragraph under the
Power Supply & Electrical info in this manual.
Clean the nozzle according to the instructions
provided in the Nozzle paragraph under the
Maintenance section of this manual.
Spray gun, lance or
high
pressure hose
leaking water Improperly
connected accessory Verify all components (gun, lance, high
pressure hose) are properly connected
according to Instructions provided in this
manual.
Low / surging
pressure or motor
does not stop when
spray gun trigger is
released
Note:
The Pressure
washer is NOT
receiving
full volume of
incoming water
The machine
requires
pressurized water
source capable
of sustaining a
minimum of 20 psi
at 5 gpm.
Faucet is not fully
open Verify incoming water supply faucet is open at
the maximum setting.
Garden hose is too
long or it is kinked /
restricted Use a maximum garden hose length of 50 ft.
(15,2 m) (city water) or 25 ft. (7,5 m) (well
water). Ensure the garden hose is laid out flat
and does not have any kinks or leaks. Unwrap
garden hose from reel or hook (if applicable).
Replace garden hose if necessary.
Water inlet fil er
screen is clogged Remove the fil er screen (O) from the water
inlet (M) and clean it thoroughly. Replace the
fil er screen.
Extension cord is too
long or wire gauge Is
too small We do not recommend using of extension
cords with your high-pressure washer. If you
must use an extension cord, verify that it
meets the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical info in this manual.
Troubleshooting Guide