Fieldmann FDP 200451-E, Руководство пользователя

Страница: 12 / 72

EN 12
FDP 200451-E
Hearing protection | Use
6. HEARING PROTECTION
WARNING!
In case the sound pressure level exceeds the value of 85.0 dB(A), wear adequate hearing protection to avoid
damage to your hearing!
7. USE
Replacing saw blades (See Fig.2)
Disconnect the saw from the mains. Loose the saw blade clamping screws (8) through the slot on the
safety guard (5) by the aid of hexagon key supplied with the tool. Remove the blade from the holder, insert
a replacement and retighten the screws. Pull the saw blade to chce that it is correctly positioned and locked in
place. Make sure that the back of the saw blade engages in the slot of the guide roller (7). Connect the saw to the
mains. Retain hexagon key in holder on saw to avoid losing it.
Adjusting the soleplate (See Fig. 4)
The soleplate (4) can be adjusted 45°(left or right) in relation to the saw direction to facilitate contour sawing.
(See Fig. 3). Loosen the two screws (10) under the soleplate, adjust the plate to the desired angle and retighten
the screws. Angle setting can be seen on scale on top of the soleplate.
Switch on and off
Connect the plug to the power supply. To start the tool, depress the ON/OFF switch trigger (1). When you release
the switch trigger, the tool turns off.
Note: For continuous operation, the switch button can be locked by pressing the lock-on button (2) at the
same time as the switch trigger. The lock-on button can be release by pressing the ON/OFF switch trigger
again.
General
Never use a blade unsuitable for the task and item to be cut.
Hold the saw in front of you with a fi rm grip on the handle.
Ensure that the saw blade is not touching anything and that the power cable is not in the way when starting
the saw.
Make sure that the item is clamped tight, and that the saw line is clearly marked.
Connect the vacuum extractor nozzle to an extractor system where possible.
Start the saw. Place the soleplate on the item, and let the saw blade touch the saw line.
Saw, but do not place more pressure on the blade than is necessary. Avoid lateral pressure on the blade.
Special notes on jig sawing
Place the soleplate on the item so the saw blade is vertical and correctly positioned in relation to the saw line
without touching it.
Start the saw and tilt it carefully while supporting it using the soleplate until the blade touches the item at the
saw line.