Fieldmann FDH 2001-E, Руководство пользователя, Страница: 16 / 20

EN 18
FDH 2001-E
Cleaning, maintanance and ordering of spare parts
1. Correct adjustment
Result: Smooth planed surfaces
2. Notches in the surface
Problem: The cutting edge on the planing knife (or both planing knives) is not parallel to the height ofthe rear
base plate.
3. Furrows at the start of the planed surface
Problem: The cutting edge on the planing knife (or both planing knives) is below the height of the rear base plate.
4. Furrows at the end of the planed surface
Problem: The cutting edge on the planing knife (or both planing knives) is above the height of the rear base plate
8.4 Replacing the drive belt
The belt should be replaced by a trained expert.
The drive belt (b) must be replaced if it is worn.
Undo the screws (a) and remove belt cover at the sides (6).
Remove the worn belt drive (b) and clean the two belt pulleys (c/d).
Place the new drive belt on the small belt pulley (c) and pull the belt onto the large belt pulley (d) whilst turning
the planing shaft.
Ensure that the longitudinal grooves on the drive belt are in the guide grooves on the drive wheels.
Fit the belt cover (6) and secure it with the screws (a).
8.5 Maintenance
There are no parts inside the equipment which require additional maintenance..
8.6 Ordering replacement parts
Please quote the following data when ordering replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to www.isc-gmbh.info