Fieldmann FDH 2001-E, Руководство пользователя, Страница: 15 / 20

EN
ELECTRIC HAND-HELD PLANER OPERATING INSTRUCTIONS
17
Cleaning, maintanance and ordering of spare parts
8
.
CLEANING, MAINTENANCE AND ORDERING
OF SPARE PARTS
Always pull out the mains power plug before starting any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the
equipent with a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment. Ensure that no water can seep into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon brushes checked only by a qualified electrician.
Important! The carbon brushes should not be replaced by anyone but a qualified electrician.
8.3. Changing the planing knives (Fig. 12-13)
Important : Always pull the plug out of the power socket before doing any work on the equipment.
To change the planing knives, use the supplied wrench (a).
The hand-held electric planer comes with two carbide metal reversible knives. Reversible knives have two
cutting edges and can be reversed. The guide slot on the reversible knives ensures the same height setting after
a change. Replace a worn, blunt or damaged knife.
Carbide metal reversible knives cannot be resharpened.
Undo the three hexagonal screws (c) using the wrench (a) supplied and push the carbide metal reversible knife
out of the planing shaft using a piece of wood. (see Fig. 12).
Clean the knife seat before fitting. Install the knives in reverse order. Check that the planing knife conforms with
both ends of the planing shaft. Always replace both knives to ensure a uniform chip depth.
Important : Before using the hand-held electric planer make sure the knives are installed securely and in
the right place.
Check the correct setting (Fig. 13)
(8) Front base plate (moving planer shoe)
(5) Rear base plate (fixed planer shoe)