7
5.
Attach the lower right arm; turn the screw until the mounting pin is at the
same level the hole on the tractor arm. If the gap between the hole and
mounting pin is too close or too distant.
2.3 WARNING FOR THE DRIVER
3.
Tractor should be in first high or fourth low gear.
7.
After attaching the harrow, lift it and adjust the control arm parallel to the
ground. When you look from both rear or sideways, the discs should all be
touching the ground uniformly.
2.
Be vigilant about the tree roots and stones. Don’t harrow on stony soil.
5.
Lift the harrow before approaching the road.
6.
Turn the control arm in or pull it away to an appropriate distance. You may
have to adjust both height and distance at the same time. When the hole
at tractor arm and mounting pin are even, insert the pin in the hole and
lock it with the lynch pin.
1.
Before harrowing check all nuts & bolts of the disc harrow.
4.
Don’t allow anyone to come across the harrow.
On your machine safety labels, the words DANGER,
WARNING, and CAUTION are used with this safety-alert
symbol. DANGER identifies the most serious hazards. The
operator’s manual also explains any potential safety hazards
whenever necessary in special safety messages that are
identified with the word CAUTION and the safety alert symbol.
E
Before harrowing with Disc harrow take care that nobody stands near it.
Before harrowing with Disc harrow, ensure that nobody stands near it.
Understanding the Machine Safety Labels
The machine safety labels shown in this section are placed in
important areas on your machine to draw attention to potential
safety hazards.
2.4 DANGER
Safety-Alert Symbol
8
In order to protect yourself always wear adequate
clothes and shoes during the operations.
Never allow riders on the tractor or implement
unless on additional seat is available.
Be careful when moving around steep gradient to
avoid sharp turn.
Never transport the implement on rough roads
during the night. When operating, avoid to make
sharp turns that may interfere with the implement.
Never use your hands to check hydraulic leaks.
Escaping hydraulic oil under pressure may have
sufficient force to penetrate the skin causing
personal injury.
Never use the implement without drawbar link
strip; it will cause damage to tractor tyre while
turning