40139-0905
1
4
Do not store electronic media, computer disks, audio-visual media or photographic negatives in this safe.
This material will not survive the rated internal temperature of the safe. This material may be damaged or
destroyed.
MODELS WITH OPTIONAL SHELVING
The shelving can be installed by locating the shelf clips to the desired locations and setting the shelf in place.
Place the safe in the desired location. Lift the carpeting up and locate the mounting hole bushings. These bushings are filled with
fire resistant caulking which must be drilled out before mounting the safe to the floor. Use a 3/8" diameter drill bit to drill out this
caulking. Continue to use this drill to mark the hole location on the floor. Move the safe away. Drill pilot holes in the floor as follows:
For a wood floor drill 5/16" diameter x 2-1/2" deep pilot holes. For a masonry floor drill 7/16" diameter x 2-1/2" deep pilot holes for
the anchors.
IMPORTANT:
When you drill out the fire resistant caulking from the mounting hole bushings you must mount the safe to
the floor using the lag bolts and gasket washers. Failure to do so will void the fire rating and waterproof rating.
Reposition the safe and secure the safe with the lag bolts and gasket washers. (Figure 4) Replace the carpeting.
IMPORTANT:
Because this safe is waterproof it will float. As the water level rises, the safe will begin to float and could fall
over causing personal injury.
The safe must be fastened to the floor using the lag bolts and gasket washer provided with this safe to insure the
waterproof rating. Failure to do so will void the waterprooof rating.
You must remove the safe from the skid and place the safe on the floor. Failure to do so will void the fire and
waterproof ratings.
SECURING THE SAFE
SELECTING A LOCATION
Your safe should be installed in an isolated, dry and secure area.
For extra humidity control we recommend the use of a desiccant. Do not drill
holes in the safe for electrical dehumidifying devices. Do not drill through the
insulation in the rear vent holes. Do not mount the safe to a wall using these
vent hole. This will void the fire rating.
For greater security the safe should be located in a corner and fastened to the
floor. (Figure 3)
HANDLE ASSEMBLY
Screw the 5 handle spokes into the hub and hand tighten. (Figure 2).
These spokes are located in the front foam packaging.
NOTE: Do not use this handle to move the safe.
INSTALLATION OF SCOPE STAND-OFF
NOTE: The scope stand-off will function properly for many
combinations of guns with scopes.
Screw the scope stand-off into the pilot hole of the barrel
rest. (Figure 1)
4
2
SAFE TOP
VIEW
3
1
Your Electronic Safe Combination:
Key #:
Serial #:
WARNING
Tip Over Hazard
A child or adult can tip the safe
and be killed or seriously injured.
Failure to secure the safe as
shown in these instructions can
result in death or serious injury
to children and adults.
Children should not play with or
around the safe.
IMPORTANT
Record the serial number from the tag on the back of the safe or
from the tag on the front bottom corner of the safe.
Keep keys and combination in a secure place away from
children. Do not store trouble key or this document in the safe.
Do not move this safe using its handle. The handle should only
be used for opening and closing the door of the safe.
Removing the back panel on the door will void the fire rating.
