FIC VT-501, Руководство по установке, Страница: 7 / 31

Installation Procedures
17
Install SIMMs
Complete the following procedures to install SIMMs:
CAUTION : Always turn the system power off before installing or removing
any device; and see “Handling Precautions” at the start of this manual.
1. Locate the SIMM slots on the mainboard. (See figure below.)
NOTE : BANK 0 and BANK 1 can use different type SIMMs - but you must
populate each memory bank with the same type of SIMM. The BIOS will
automatically configure the memory size.
2. Carefully fit a SIMM at a 45
degree angle into each empty
sockets to be populated. All the
SIMMs must face the same
direction.
3. Swing each SIMM into its
upright, locked position.
When locking a SIMM
in place, push on each end of the SIMM -
do not push in the middle, as shown above.
Remove SIMMs
To remove the SIMMs, pull the retaining latch on both ends of the socket and
reverse the procedure above.