2
Electrical Restrictions
WARNING:
This equipment is designed for connection to a grounded (earthed) outlet. The grounding type plug
is an important safety feature. To reduce the risk of electrical shock, damage to your equipment,
or loss of data, do not disable this feature.
Power Cord Set Requirements
The power cord set (appliance coupler, flexible cord, and wall plug) you received with the AquaPAD meets the
requirements for use in the country where you purchased the equipment.
Power cord sets for use in other counties must meet the requirements of the country where you use the AquaPAD.
For more information on power cord set requirement, contact your local authorized dealer, reseller, or service
provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.0 feet (1.8 m) and a maximum of 14.76 feet (4.5 m).
2. All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the
country where the power cord set will be used.
3. The power cord set must have a minimum current capacity of 10A and a normal voltage rating of 125 or 250
volts AC, as required by each country’s power system.
4. The appliance coupler must meet the mechanical configuration of an EN 60320. / IEC 320 Standard Sheet C13
connector, for mating the appliance inlet on the AquaPAD.
Country-Specific Requirements
Power Cord Set Requirement
Country
Accredited Agency
Applicable Note Numbers
Australia EANSW
1
Austria OVE
1
Belgium CEBC
1
Canada CSA
2
Denmark DEMKO
1
Finland FIMKO
1
France UTE
1
Germany VDE
1
Italy IMQ
1
Japan JIS
3
The Netherlands
KEMA
1
Norway NEMKO
1
Sweden SEMKO
1
Switzerland SEV
1
United Kingdom
BSI
1
United States
UL
2
Note:
1. Flexible cord must be <HAR> Type HO5VV-F, 3-conductor. 1.0 mm
2
conductor size. Power cord set fittings
(appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the
country where it will be used.
2. Flexible cord must be Type SVT or equivalent. No. 18 AWG, 3-conductor. Wall plug must be a two-pole
grounding type with a NEMA 5-15P (10A. 125V) or NEMA 6-15P (15A 250V) configuration.
3. Appliance coupler, flexible cord, and wall plug must bear a “T” mark and registration number in accordance with
the Japanese Dentori Law. Flexible cord must be Type VCT or VCTF, 3-conductor, 0.75mm
2
conductor size.
Wall plug must be a two-pole grounding type with a Japanese Industrial Standard C8303 (15A, 125V)
configuration.
