6/16
Instructions for use WPM Repeater
Commissioning
config wifi-iface
- option device 'radio0'
- option network 'wwan'
- option mode 'sta'
- option ssid 'YOUR_SSID'
- option encryption 'psk2'
- option key
'YOUR_PASSWORD'
6) Plug in the power supply unit and switch on the device.
7) Plug the USB stick with the configuration into the repeater.
8) The LED ring on the repeater changes to a green/blue LED and starts to fill the LED circuit
slowly.
9) When the LED ring is completely lit in green, you can remove the USB stick and the instal-
lation was successful.
Note:
If the LED ring lights up red, there was an error during the installation. Check the pos-
sible solutions in the Troubleshooting chapter.
10) The repeater will then attempt to establish the connection with the WPM cloud. When the
LED ring lights up completely orange, the process has been successful and the repeater
should be reported as connected in the WPM cloud.
Note:
If the LED ring does not light up completely in orange, check for possible causes in
the Troubleshooting chapter.
