http://www.fiberstars.com
79-15103-00 REV. B
Page 7 of 11
Flathead Screwdriver
Repeater Mounting
The WPC-04R is equipped with a signal repeater that can be mounted up to 10 feet from the
WPC-04R unit. This repeater receives signals from the wireless remote and sends that signal to
the WPC-04R via the 10 foot cable. Establish a location for the Repeater that is in line of sight
from where the wireless remote will be used most frequently and that is no more then 75 feet from
furthest where the remote will be used. NOTE: If extension is needed, use Fiberstars part
number 94-15098-00 and follow installation instructions supplied with the Repeater Extension.
To mount the Repeater, carefully insert a small flathead screwdriver into groove between the
Dome and Base approximately where the locking dimples are located. Pry the Dome out of on of
the locking dimples. Then carefully insert the small flathead screwdriver into the groove between
the Dome and the Base in an adjacent locking dimple and pry the Dome out. Then separate the
Dome from the Base by hand. Using the supplied self-drilling screws, locate a suitable mounting
surface and screw the base to this surface. Note that the marking “TOP” must be in the 12
o’clock position and the wire slit must be in the 6 o’clock position. Do not over tighten the
screws as it may damage the Repeater base. Realign the Repeater Dome to the Base and ensure
that the wire is exiting the base through the slit and the Locking Dimples are aligned with the
10 feet
Repeater
Dome/Base groove
Locking
Dimple
Orientation
Marker
Mounting
Holes
Base Slit for
Repeater Wire
Repeater Dome
Repeater Base
Mounting Screws