FiberLamp FL5600, Инструкции по эксплуатации

Страница: 7 / 19

FiberLamp Manual Operation Page 7 of 20
Copyright 2015 5870082 A1
MODE
The “Mode” pushbutton is used to select through preset lighting modes saved on the fixture.
Each mode is either a static color or a Playlist. A static color mode can only display one solid
color. A Playlist mode can display a timed sequence of color scenes. Modes 1-7 can only be
programmed as static colors. Modes 8-11 can be programmed as static colors or Playlists.
Table 2 lists the factory-preprogrammed settings for each model of FL5600. All modes, except
for mode 0, can be reprogrammed using the LightMix software described in section 4 of this
manual.
Table 2: Factory preset modes
Mode
Programming
Capability
Multicolor
Single Color
RGBW RGBA
0 Non-programmable No light No light No light
1 Static Color White Blue 100% Intensity
2 Static Color Red Red 90% Intensity
3 Static Color Green Amber 80% Intensity
4 Static Color Blue Green 70% Intensity
5 Static Color Yellow Orange 60% Intensity
6 Static Color Cyan Chartreuse 50% Intensity
7 Static Color Mixed 5000K White Mixed 5000K White 40% Intensity
8 Playlist Rainbow Playlist Rainbow Playlist Blank
9 Playlist Blank Blank Blank
10 Playlist Blank Blank Blank
11 Playlist Blank Blank Blank
Note: The Rainbow Playlist slowly fades between colors, while mixing to display all colors on the color pallet.
VR INTENSITY
To adjust the intensity in the outdoor model, unscrew the eight screws on the top, remove the
cover. It is located in the bottom right hand corner of the FL5600. The intensity can be adjusted
in Mode 0 through Mode 7.