Fiat DOBLO 2015, Руководство пользователя

Страница: 107 / 244

105
(Comfort-matic or Dualogic™ )
transmission, before putting the gear
lever in the
P
position.
IMPORTANT NOTES
With the vehicle stationary and a gear
engaged, always keep the brake pedal
pressed until you decide to set off,
then release the brake and accelerate
gently;
during prolonged stops with the
engine running, it is advisable to keep
the gearbox in neutral (N);
In order to safeguard the efficiency of
the clutch, do not use the accelerator
to keep the vehicle stationary (e.g.
when stopped on an incline);
the clutch could overheat and be
damaged; use the brake pedal and
only operate the accelerator pedal
when you decide to set off;
only use second gear when you need
greater control for starting manoeuvres
on surfaces with poor grip;
if, with reverse gear (R) engaged,
you have to engage first gear or vice
versa, only do this when the vehicle
is completely stationary and with the
brake pedal pressed;
although it is strongly inadvisable,
if you are driving downhill and, for
unexpected reasons, you let the vehicle
move forward with the transmission in
neutral (N), when you engage a gear,
the system will automatically engage
the best gear to transmit the correct
drive torque to the wheels depending
on the vehicle's speed;
WARNING
92) The vehicle should be secured
after several clicks of the lever. If it is
not, contact a Fiat Dealership to have it
adjusted.
93)
Never leave children unattended in the
vehicle. Always remove the key from the
ignition device when leaving the vehicle
and take it out with you.
94) In the case of parking manoeuvres
on roads on a gradient, the front wheels
must be steered towards the pavement
(when parking downhill), or in the opposite
direction if the vehicle is parked uphill. If
the vehicle is parked on a steep slope,
it is advisable to block the wheels with a
wedge or stone.
USING THE
GEARBOX
To engage the gears, press the clutch
pedal fully and put the gear lever (A)-
fig. 133 into the required position (the
diagram for gear engagement is shown
on the lever knob fig. 133).
133
F0V0069
WARNING Reverse may only be
engaged when the vehicle is at a
standstill. With the engine running, wait
for at least 2 seconds with the clutch
pedal fully depressed before engaging
reverse to prevent damage to the gears
and grating.
To engage reverse R from neutral,
lift ring (B) under the knob and at the
same time move the gear lever to the
right and then backwards (as shown in
the diagram).
95) 25)