Fiat 500L 2015, Руководство пользователя

Страница: 87 / 148

To erase the channels, place the ignition switch into the ON/RUN position, then push and
hold the two outside HomeLink® buttons (I and III) for up to 20 seconds or until the
red indicator flashes
.
NOTE:
Erasing all channels should only be performed when programming HomeLink® for the
first time
.
Do not erase channels when programming additional buttons
.
If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on
the Internet at HomeLink
. com for information or assistance .
Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995
.
These Garage
Door Openers can be identified by the “LEARN” or “TRAIN” button located where the
hanging antenna is attached to the Garage Door Opener
. It is NOT the button that is nor-
mally used to open and close the door . The name and color of the button may vary by
manufacturer
.
1 . Place the ignition switch into the ON/RUN position .
2 . Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink®
button you wish to program while keeping the HomeLink® indicator light in view
.
3
.
Push and hold the HomeLink® button you want to program while you push and hold
the hand-held transmitter button
.
4 . Continue to hold both buttons and observe the indicator light . The HomeLink® indi-
cator will flash slowly and then rapidly after HomeLink® has received the frequency
signal from the hand-held transmitter
. Release both buttons after the indicator light
changes from slow to rapid .
5
.
At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING”
button
.
This can usually be found where the hanging antenna wire is attached to the ga-
rage door opener motor . Firmly push and release the “LEARN” or “TRAINING” button .
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pushed
.
6
.
Return to the vehicle and push the programmed HomeLink® button twice (holding
the button for two seconds each time)
. If the device is plugged in and activates, pro-
gramming is complete .
NOTE:
If the device does not activate, push the button a third time (for two seconds) to com-
plete the training
.
7
.
To program the remaining two HomeLink® buttons, repeat each step for each re-
maining button
.
DO NOT erase the channels
.
ELECTRONICS
85