4
.
Position the lap belt so that it is snug and lies low across your hips, below your abdo-
men
.
To remove slack in the lap belt portion, pull up on the shoulder belt
.
To loosen
the lap belt if it is too tight, tilt the latch plate and pull on the lap belt
.
A snug seat
belt reduces the risk of sliding under the seat belt in a collision
.
5
.
Position the shoulder belt across the
shoulder and chest with minimal, if any
slack so that it is comfortable and not
resting on your neck
.
The retractor will
withdraw any slack in the shoulder belt
.
6
.
To release the seat belt, push the red
button on the buckle
.
The seat belt will
automatically retract to its stowed posi-
tion
.
If necessary, slide the latch plate
down the webbing to allow the seat
belt to retract fully
.
Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/shoulder belt
.
1
.
Position the latch plate as close as possible to the anchor point
.
2
.
At about 6 to 12 inches (15 to 30 cm) above the latch plate, grasp and twist the seat
belt webbing 180 degrees to create a fold that begins immediately above the latch
plate
.
3
.
Slide the latch plate upward over the folded webbing
.
The folded webbing must enter
the slot at the top of the latch plate
.
4
.
Continue to slide the latch plate up until it clears the folded webbing and the seat
belt is no longer twisted
.
Seat Belt Extender
If a seat belt is not long enough to fit properly, even when the webbing is fully extended
and the adjustable upper shoulder belt anchorage (if equipped) is in its lowest position,
your authorized dealer can provide you with a Seat Belt Extender
.
The Seat Belt Ex-
tender should be used only if the existing seat belt is not long enough
.
When the Seat
Belt Extender is not required for a different occupant, it must be removed
.
Positioning The Lap Belt
GETTING STARTED
29
Содержание 500e 2017
Страница 162: ...NOTES 160...