Rolling Code Garage Door Opener Final Steps
NOTE:
You have 30 seconds in which to initiate rolling
code final step 2, after completing rolling code
final step 1
.
1
.
At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAIN”
button
.
This can usually be found where the
hanging antenna wire is attached to the garage
door opener motor
.
Firmly push and release
the “LEARN” or “TRAIN” button
.
2
.
Return to the vehicle and push the pro-
grammed HomeLink button three times
(holding the button for two seconds each
time)
.
If the garage door opener motor
operates, programming is complete
.
3
.
Push the programmed HomeLink button to
confirm that the garage door opener motor
operates
.
If the garage door opener motor
does not operate, repeat the final steps for the
rolling code procedure
.
Non-Rolling Code Garage Door Opener Final
Steps
1
.
Push and hold the programmed HomeLink
button and observe the HomeLink indicator
light
.
If the HomeLink indicator light stays on
constantly, programming is complete
.
2
.
Push the programmed HomeLink button to
confirm that the garage door opener motor
operates
.
If the garage door opener motor
does not operate, repeat the steps from the
beginning
.
WARNING!
• Your motorized door or gate will open and
close while you are programming the uni-
versal transceiver
.
Do not program the
transceiver if people or pets are in the
path of the door or gate
.
• Do not run your vehicle in a closed garage or
confined area while programming the trans-
ceiver
.
Exhaust gas from your vehicle contains
Carbon Monoxide (CO) which is odorless
and colorless
.
Carbon Monoxide is poisonous
when inhaled and can cause you and others
to be severely injured or killed
.
Programming HomeLink To A Miscellaneous
Device
Refer to “Programming HomeLink To A Garage
Door Opener” for the procedure on how to
program HomeLink to a miscellaneous device, as
it follows the same procedure
.
Be sure to deter-
mine if the device has a rolling code, or non-
rolling code before beginning the programming
process
.
NOTE:
Canadian radio frequency laws require transmit-
ter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal during
programming
.
Similar to this Canadian law, some
U
.
S
.
gate operators are designed to time-out in
the same manner
.
The procedure may need to be
preformed multiple times to successfully pair the
device to your HomeLink buttons
.
GETTING
T
O
KNO
W
Y
OUR
VEHICLE
34
Содержание 500 L 2019
