WARNING!
• Remove any metal jewelry such as rings,
watch bands and bracelets that could make
an inadvertent electrical contact
.
You could
be seriously injured
.
• Batteries contain sulfuric acid that can burn
your skin or eyes and generate hydrogen gas
which is flammable and explosive
.
Keep open
flames or sparks away from the battery
.
1
.
Apply the parking brake, place the transmis-
sion in PARK and turn the ignition OFF
.
2
.
Turn off the heater, radio and all unnecessary
electrical accessories
.
3
.
Remove the protective cover over the remote
positive
(+)
battery post
.
To remove the cover,
pull upward on the cover
.
4
.
If using another vehicle to jump start the
battery, park the vehicle within the jumper
cables reach, set the parking brake and make
sure the ignition is OFF
.
WARNING!
Do not allow vehicles to touch each other as
this could establish a ground connection and
personal injury could result
.
Jump Starting Procedure
WARNING!
Failure to follow this jump starting procedure
could result in personal injury or property
damage due to battery explosion
.
CAUTION!
Failure to follow these procedures could result
in damage to the charging system of the
booster vehicle or the discharged vehicle
.
Connecting The Jumper Cables
1
.
Connect the positive
(+)
end of the jumper
cable to the positive
(+)
post of the dis-
charged vehicle
.
2
.
Connect the opposite end of the positive
(+)
jumper cable to the positive
(+)
post of the
booster battery
.
3
.
Connect the negative
(-)
end of the jumper
cable to the negative
(-)
post of the booster
battery
.
4
.
Connect the opposite end of the negative
(-)
jumper cable to a good engine ground (ex-
posed metal part of the discharged vehicle’s
engine) away from the battery and the fuel
injection system
.
WARNING!
Do not connect the jumper cable to the
negative (-) post of the discharged battery
.
The
resulting electrical spark could cause the bat-
tery to explode and could result in personal
injury
.
Only use the specific ground point, do
not use any other exposed metal parts
.
5
.
Start the engine in the vehicle that has the
booster battery, let the engine idle a few
minutes, and then start the engine in the
vehicle with the discharged battery
.
6
.
Once the engine is started, remove the
jumper cables in the reverse sequence
.
103
Содержание 500 L 2019
