Fiat 124 Spider Abarth 2018, Руководство пользователя

Страница: 165 / 252

8. Install the air compressor hose,
which was pulled out of the air
compressor, into the injection valve of
the bottle.
Note: Make sure that the air
compressor switch is off before
inserting the air compressor hose into
the injection valve of the bottle. If the air
compressor hose is not installed to the
injection valve of the bottle securely, the
sealant may leak.
9. Remove the valve cap from the valve
of the flat tire, install the injection hose
to the tire valve, and turn the sleeve to
the right to tighten.
10. Install the bottle to the air
compressor and push it in until the left
and right tabs are engaged securely.
11. Insert the air compressor plug into
the accessory socket, located deep in
the back of the footwell on the
passenger side, and cycle the ignition
to ACC.
Note: When inserting the air
compressor plug into or removing it
from the accessory socket, make sure
that the air compressor switch is off.
When turning the air compressor on/off,
use the air compressor switch. Before
checking the tire inflation pressure using
the tire pressure gauge, turn the air
compressor switch off.
12. The sealant is injected into the tire
when the air compressor is switched
on. After the sealant is injected
completely, wait until the tire inflation
pressure increases to the specified tire
inflation pressure. For the correct
pressure, check the tire inflation
pressure label on the driver's door
frame.
Note: The inflation pressure may
increase to about 43.5 psi (3 Bar)
temporarily to inject the sealant through
the valve. Normally, the inflation
pressure decreases gradually and it
reaches the actual inflation pressure
after about 30 seconds.
08020202-031-670
Install Air Compressor To Sealant
Bottle
3 — Air Compressor Hose
4 — Injection Valve
08020202-03A-004AB
Valve And Valve Cover
5 — Valve Cap
6 — Valve
08020202-031-669
Sealant Bottle Into Air Compressor
7 — Air Compressor Tabs
163