8
INSTALLATION
Before installing the machine, make sure that the machine has all the required conditions to work
correctly.
IMPORTANT:
- Do not install the machine in locations where jets of water may occur.
- The machine should be installed in locations where its use and servicing are restricted to fully
trained and authorised personnel.
- During installation, the machine must be well levelled up and in case there’s some degree of
inclination, it must never exceed 1 degree either way.
Therefore:
1
- Check that the electrical installation has all the conditions in order to work correctly.
1.1. - Check if the power supply corresponds to the one required for the machine (see the
ID plate)
1.2. - Check if there is a suitable earth circuit.
1.3. - Check if the available power is suitable for the machine power.
1.4. - The electrical board should have a protection of 30 mA and a circuit breaker with a
3mm separation from the contacts.
2
- Check that the water circuit has the required conditions for installation:
2.1. – The feeding/wall tap must be prepared to have a G3/8 nut for connection to the
feeding hose.
3
- Check that there is an accessible discharge pipe that can hold a pipe with 16/17 mm.
4
- There must be enough space for placing a water softener or any other anti-scale filter,
connected to the machine.
IMPORTANT
“THE EARTH CONNECTION IS COMPULSORY”
The machine is to be connected to an electric fixed installation and thus the use of wall sockets,
multiple plugs or extension cords is strictly forbidden.
At the bottom of the machines there’s a terminal marked which allows the equipotential
connection between several machines.
