13
Programming
General
Use the Programming menu to modify the operating settings of the telephone. After lifting the
handset or pressing the disconnect key, a welcome message appears in the display.
Begin the programming procedure by pressing the key.
In the top line of the display, the text „Main menu“ appears. In the second line, you see the
first menu item of the Main menu. The arrow > in front of the menu item indicates that this
item has been selected. Provided you have access to other menu items, pressing the key
takes you to the next menu items, one at a time. Pressing the key takes you back to the
top of the list of menu items.
The display shows a maximum of two menu items. When an arrow > is visible in front of an
item, it indicates that the item has been selected. The menu items denote further sub-menus.
Pressing the key activates a selected menu item.
Any sub-menu may contain further sub-menus as menu items. These sub-menus are
selected in the same manner as in the Main menu. Press the key to go to a higher menu,
or to leave the Main menu.
At the lower menu levels, so-called radio buttons are displayed for the selection of possible
settings.
Example:
Display
Significance
---Activate---
Title line
( ) None
Activated option
( ) Direct call
Option
>( ) No calls
Selected option
=== End===
End of menu list
Pressing the C key activates a selected option.
In certain menus, values may be changed. These changes are made by pressing the and
keys.
For all programming goes: Changes are applied and stored upon pressing the key only.
By pressing the key, you leave the menu without applying the changes.
If a programming session has not been completed, the telephone leaves the Programming
menu after a certain amount of time (time-out).
If you want to modify the settings, you will be required to enter a four-digit PIN. The PIN set
by the factory is 0000.
Initial programming
In the as-delivered condition, the telephone already has a basic configuration enabling you to
make and answer calls. If you want certain settings regarding telephone book entries,
volume, dialling mode, or operation from private branch exchanges, you must use the
Programming menu.
Press the key to go to the Main menu.
The sub-menu „Programming“ appears. Pressing the key takes you to the next level,
where you may activate the sub-item „allow“ by pressing the C key. You will be prompted to
enter the PIN (factory setting 0000). Programming is now allowed, and the complete Main
menu is at your disposal, including the following items:
- Telephone book
- Short /
Speed code dialling
- Settings
In order to program the telephone, you have to allow modifications of the settings.
