Sidus F1B – free flight electronic timer
8/11
JUMP2
JUMP2
JUMP2
JUMP2
Exit
Exit
Exit
Exit Servo
Servo
Servo
Servo
SET menu
5. Press and release T3 or T4 to reach the wished function (e.g. FUNC5), then press and
hold T1 until the POSITION menu is displayed:
6. Press and release T3 (pos+) or T4 (pos-) to accurately adjust the disc position for the
current function (Keep T3 or T4 pressed to have a faster movement). The new
positions are permanently stored
7. Press T2 (ESC) to go back to the FUNCTION menu and repeat the steps above to
adjust the disc position of another function or press again T2 (ESC) go back to the
SET menu.
Intermediate step in case of early radio DT
When the RDT is activated (e.g. while the engine is running) it is possible set the Timer to
have the disc jumping to an intermediate function (JUMP2 function) safer than DT, helpful
to prevent model damage. If the RDT is activated again (or if it is activated after the
JUMP2 function), the disc will immediately jump to DT (see the example below).
Example: engine stop is FUNC1, bunt is FUNC2, rudder is FUNC3, first glide is FUNC4,
JUMP2 function is set to FUNC2
•
In case of RDT during FUNC1, the Timer terminates FUNC1 and jumps to FUNC2.
The timing continues. In case of further RDT activation the model is instantly
dethermalized
•
In case of RDT later than FUNC1 the model is instantly dethermalized
JUMP2 function setting
1. Aim the Programmer at the Timer (make sure it is ON)
2. Through the FUNCTION menu (see “Disc positioning modification”) move the disc
to the function the disc must jump to (JUMP2 function) in case of early DT
3. Press and release T2 (Exit) to exit the FUNCTION menu and enter the SET menu:
4. Keep T3 (JUMP2) pressed until getting the message “
Writing
Writing
Writing
Writing
…
”
5. Double check the settings: start the timer, push the RDT button once during the
function(s) before JUMP2 function and check that the disc jumps to JUMP2.
Push the RDT button again and check that the discs jumps to DT (end of travel)
FUNC5 pos+
FUNC5 pos+
FUNC5 pos+
FUNC5 pos+
Exit
Exit
Exit
Exit pos
pos
pos
pos-
--
-
POSITION
menu