FF Systems FF-8070, Руководство по эксплуатации

Страница: 12 / 25

10
Track Interrupt Mode <spi prefix> + <069> ; <mode> Enable/Disable play track interrupt
default 130069 interrogate
1300690 no interrupt
1300691 DTMF interrupt
1300692 COS interrupt
There are three interrupt modes available on the FF-8070:
RESPONSE
DESCRIPTION
"I N T Cancel" <mode> = 0, No interrupt allowed -- all tracks will play to completion
"I N T D T M F" <mode> = 1, Only interrupt if a DTMF digit is detected
"I N T C O S" <mode> = 2, Interrupt if DTMF or COS detected during play
These modes allow the user to set the play interrupt mode for their DVR. <mode> = 1 is most
generally recommended for users who do not want COS interrupt of DVR tracks because it still
allows an interrupt mechanism that is available (pressing a DTMF digit) to terminate a track play if
desired.
Save Config. Flags <spi prefix> + <067800> Set configuration flags to EEPROM
default 130067800
This command "saves" the status of the configuration flags register. On reset, this register is
recalled from EEPROM so that the contents can continue to reflect the user's desired setting. The
configuration flags save the Blank annunciate flag and the interrupt mode. Changes made to these
settings will not be retained until saved with this command. Also, the auto erase time is saved with
this command.
Clear Mail Codes <spi prefix> + <0581800> Clear mail suffixes
default 1300581800
This command should be executed anytime that the voice mail command codes are to be changed. This
resets the function codes to the factory defaults which can help reduce difficulties that may be encountered
with the FF-8070 code checking procedure.
Auto Play delay <spi prefix> + <0580> ; <t> Set or interrogate the auto play delay
default 1300580t
This command is used to set the auto play delay from <t> = 0 to 9 minutes. The auto play delay
affects tracks 100 and 101 and prevents them from being played if a user enters the "List active
messages" command within the time set by this command. The factory default is 3 minutes.
Auto Erase delay <spi prefix> + <0582> ; <t> Set or interrogate the auto erase delay
default 1300582t
This command is used to set the auto erase delay from <t> = 0 to 255 hours. The auto erase time
is attached to each voice mail message when it is recorded. When the time expires, the message is
automatically erased. <t> = 0 hours disables the auto erase feature -- the factory default time is 255
hours, or a little over 10 days. This parameter must be saved using the Save Config. Flags
command.
FF-800 Interface Programming
The FF-800 allows any of the system tracks to be entered into speech messages on the FF-800 via the
"[SPI]" speech phrase macro (word# 182). When the message is processed by the FF-800, the