Chapter 2–Setting Up the Mobile Terminal
© 2019 Fexco. All rights reserved.
9
2.2
Configuring the Bluetooth Terminal
The Vx 680 Bluetooth (Vx680‐B) terminal uses the full‐feature charging station to go online for
authorisation either via IP or PSTN.
The Vx680‐B terminal can only communicate through a charging station to which it has been paired. If
you have more than one Bluetooth terminal on‐site, then each terminal must be paired with its own
charging station. See “Section 2.2.2, Pairing the Charging Station with the Terminal” on page 10.
Figure 2.1
Bluetooth charging station LEDs
The charging station’s status is indicated by the following LEDs:
2.2.1 Bluetooth Charging Station Requirements
The Bluetooth charging station requires the following:
•
Power source within two meters
•
Telephone socket within three meters (for PSTN version)
•
Location with minimal obstruction for communication with its paired terminal
•
For optimal performance, the charging station should be placed in a position that will service all of
the card payment areas on the premises. The ideal placement is to position the charging station
within a line of sight to all areas of card acceptance.
•
The charging station must be installed two meters from the ground to allow the LEDs to be seen,
and the state of the connection to be confirmed.
LED
Indicates
POWER
The charging station is powered ON and ready for communication with its paired terminal.
BLUETOOTH
A radio connection is made and the charging station is communicating with its paired terminal.
DATA TRANSMISSION
The charging station is online and transmitting data (through its modem over a PTSN line).
Power
Bluetooth
Data Transmission
