Festool LEX 3 125/3, Оригинальное руководство по эксплуатации

Страница: 12 / 16

12
LEX 3
– If symptoms such as malaise, complaints,
throbbing, pain, tingling, numbness, burning
or stiffness occur inform your employer and
consult a doctor.
Risk as a result of accessory parts
– Disconnect the compressed air hose from the
compressed air supply. In the event of non-use
of the compressed air tool, before maintenance
and when changing insertion tools.
– Avoid contact with the insertion tool during and
after use.
– Always use original accessories.
– Grinding wheels and cutting-off wheels are not
permitted.
– The permissible rotational speed of the
accessory must be at least 1,000 rpm higher
than the maximum speed specified on the
machine. Accessories that rotate faster than
the permissible level can rupture.
– Self-adhesive abrasives must be attached
concentrically on the sanding pad.
Risk at work station
– Slipping and tripping hazard! Pay attention to
slippery surfaces and tripping hazards as a
result of air pressure hoses.
– Not intended for use in explosive atmospheres
and not insulated against contact with electrical
power sources.
– Proceed with caution in unfamiliar surroundings
that may contain electrical or other supply
cables that harbour hidden dangers. Ensure
that there are no electrical cables, gas pipelines
or similar that, if damaged, could pose a hazard
when the machine is used.
Hazard as a result of dust and vapours
– If hazardous dust is produced during sanding,
the machine should be connected to an
appropriate extractor and the safety regulations
that apply to the working material should be
observed.
– A risk assessment in relation to this hazard
must be carried out and corresponding control
mechanisms implemented. Arising dust must
be factored in.
– Connect the dust extractor. Make sure that
available dust extraction equipment is connected
and used correctly. Observe the regional safety
regulations for hazardous dusts and vapours.
Operate and service the compressed air tool
as described in the recommendations included
in these instructions and use accessories
and attachments from Festool to minimise
the release of dust and vapours into the
atmosphere. In dusty environments, make sure
that the dissipation of exhaust air does not
disturb the dust.
– If necessary arising dust or vapours must be
controlled at the place of their release.
– All components must be fitted correctly and
meet all requirements to ensure that the
compressed air tool operates correctly.
– Select, maintain and replace accessories and
consumables according to these operating
instructions.
– Wear a dust mask. Observe instructions from
the employer or occupational and health
regulations.
Noise hazard
– Higher noise level can lead to permanent
hearing damage, loss of hearing or other
problems if inadequate hearing protection is
not worn or available.
– A risk assessment in relation to this hazard
must be carried out and corresponding control
mechanisms implemented, e.g. the use of
insulating materials.
– Wear ear protection. Observe instructions
from the employer or occupational and health
regulations.
– Operate and maintain compressed air tool
according to these operating instructions.
– Select, maintain and replace accessories and
consumables according to these operating
instructions.
– Assure function of the silencer at the compressed
air tool.
Vibration hazard
– Vibrations can cause damage to nerves and
problems with blood circulation in hands and
arms.
– When working in cold environments wear warm
clothing and keep hands warm and dry.
– In the event of numbness, tingling or pains in
fingers or hands or white colouration of the
fingers or hands, cease work, inform employer
and consult a doctor.
– Operate and maintain compressed air tool
according to these operating instructions.
– Do not hold the compressed air tool too tight,
but with a secure grip while observing the
necessary hand reaction forces. The vibration
risk is greater with increasing gripping strength.